Ford wheel stud

[CRF6179]

I needed to remove the wheel from the Ford 14D. I started removing the bolts and found that two of them were studs.
I don't know if that was done from the factory or if a PO did it, but it sure was nice when reinstalling the wheel. Rick

 

[KennyP]

According to the parts list, those studs are factory!

 

[MH81]

Nice idea. Especially for the hubs that don't have the allignment lip.

 

[KennyP]

Those are M10 threads, not sure if they would work on any of the older equipment.

 

[MH81]

Those are M10 threads, not sure if they would work on any of the older equipment.

I suppose guys could make them. They'd almost have to be done a few at a time, custom.
Some of my Sears are fine thread, some coarse. (Aluminum hub vs steel, I think)
A piece of alltread, some good threadlocker and a tapered nut.... Should work.

 

[dodge trucker]

M10? REALLY? I wouldn't have expected them to be metric.... Id expect them to be 7/16 -20, or 1/2-20.

 

[KennyP]

M10? REALLY? I wouldn't have expected them to be metric.... Id expect them to be 7/16 -20, or 1/2-20.

That's what the parts list said at NH.

 

[Texas Horses Hogs and Deeres]

M10? REALLY? I wouldn't have expected them to be metric.... Id expect them to be 7/16 -20, or 1/2-20.

I believe this is a Japanese import diesel for Ford.