Kohler K321 carb linkage

[Lily'sDad]

I need to make a replacement carb linkage for a K321. This is the linkage that connects the governor lever to the carb throttle lever. It is a straight piece of wire with a short 90 degree bend on each end and uses a plastic clip to keep it in place.
What I am asking is if you can provide me the measurements for the wire.
Thanks!

 

[MFDAC]

I'm afraid mine doesn't have the plastic clips, LD. Older than yours I suppose. It's a 1978 K321S.

DAC

 

[dodge trucker]

yeah there were a couple of different styles. some had a turnbuckle in them for adjustment. some were a ~1/16" wire, some were a ~3/16" threaded rod.

 

[4getgto]

If you can try placing some drill bits through the holes to give you an idea what gauge wire you should use..
Do you have the plastic clips ?

 

[Lily'sDad]

Please, I only need the measurement of the overall length.