I had a chance to make up the pivot point to for the pedals (this unit was opposite), the chamfered ends of the bolts you see was welded to the original rod after I cut it to length. There's lots of adjustment here. It sits with the rod end bearings stacked up & down and pivots roughly 3/4" in both directions for travel. The flat bar with the bushing bolts to the inner channel of the frame & the pivot goes inside it.
The free wheel rod was too short so I made up a new one.
I could only use the K46 fan but the splined shaft on the K71 was shorter so I faced off about 1/4" off the pully so the fan could go on, fits good & is in the original position.
The free wheel rod was too short so I made up a new one.
I could only use the K46 fan but the splined shaft on the K71 was shorter so I faced off about 1/4" off the pully so the fan could go on, fits good & is in the original position.