The axle shaft. Jumpins I’ve been a fightin this thing on and off for a month, I think. Put puller on it at the first, oiled and tighten up puller. Every other day I hit puller and turn it a little. So tried that for a while. Didn’t seem to be working. Next I tried using a map gas torch on it. Not much luck there either. Next, last week, I use acetylene and oxygen torch. Got it to move about 1/4”. Today I used the map gas again. Hardly any acetylene left and want to save that if I could. Every thing so expensive to run a hobby shop. Any way it moved, so turning and tapping puller it kept going. Used the map gas once more. Then it would move without using the heat. A half turn on puller, a few taps, more turning and tapping. Had to do that right to the end. Wheel is on the shaft two and three quarters of an inch. So now I can put a tube in the tire. And I’m gunna pull the other wheel off and anti seize it too. No leak in other wheel.
Had did a post about this, I think, asking for ideas how to get it off, but can’t find it now.
Noel
Had did a post about this, I think, asking for ideas how to get it off, but can’t find it now.
Noel