Wally world was for the better half. She did come i n to HF with me to keep me in check.H-F oh yeah !
Wally world, I could care less.
Sears 40" Sickle Mower 917.253120 restore.
- Thread starter larrybl
- Start date
Guess I'll try plan "B"
bontai Joe said: You could grind the edges of the cutter bar and then shoot a coat of clear over it to seal out the rust causing moisture. Just suggestin'.
bontai Joe said: You could grind the edges of the cutter bar and then shoot a coat of clear over it to seal out the rust causing moisture. Just suggestin'.
The mower will be sooooo nice when completed, I would hate to see it cut! You're building a show piece.
Nothing like having one hand covered in grease, then needing it.
Yep, I left that part in and edited out all the other struggles.
I sure hope this mounts to the Roper. I have been over the manual several times and I will need to slide this under the tractor to figure it out.
Did you search on McMaster-Carr.com for the bushings?
McMaster-Carr
McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.
I was going to try there, but for what this will be, brass works fine.Did you search on McMaster-Carr.com for the bushings?
McMaster-Carr
McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.www.mcmaster.com
I think I have a geometry issue, and I am not good at geometry.
For some reason, the part-29 vid screen ratio is a smaller size uploaded to YT.
Not sure what is going on. I rendered the video again and the export was the same. Might be an issue with the YT upload. I'll check that with the next video upload.For some reason, the part-29 vid screen ratio is a smaller size uploaded to YT.