Recent content by MH81

Several weeks back, our local club (who is trying to get going again following the mayhem of the last two and a half years) tried to do a road ride and reorganizational meeting We were able to have the meeting, but the road ride was a wash. Literally. It rained an inch and a half in about 3.5...

We found out about this event that they have in a rural community near us. It's difficult for the kids to do any trick or treating because of how far apart the houses are and how sparse the population is. Hardly makes it worth dressing up or buying a costume for four Snickers bars... Anyways...

Looks like someone has been very productive. Congratulations, looks great

Nice looking Craftsman. Thanks for posting.

I sent Casey a screenshot of this.

These appear to be polarized... Doesn't say DC. Bottom line, second pic

I'm sure that Mutt and Jeff will appreciate it.

I have a set that I saved for. Impact, hammer drill, sawzall, flashlite, oscillating cutter, 7.25” saw, 4.5” grinder. Damn nice stuff. I use it at home and work.

Is it 2 or 4 stroke?

Kenny, if you want the 3 point to float, you can sleeve the end of the cylinder and make a pin to go thru for the times you want down pressure.

On the old truck, we.had a diode that was on the brake light wire and it could go up and charge.the battery. not sure how all the new electronics would like something like that, but it sure did work well back in the day

That dog'll hunt

Next, you'll tell us you were cutting tape with the paper shredder. Glad it wasn't worse.

It's like the first day with a new sand pile. I have no intention on firing up any of my snow equipment unless I have to.