I am trying to rebuild my old cast iron Briggs motor, model #325431-0139-01 and I don't know how to get the camshaft out of the block. Is there a stubshaft that needs to be driven out of the end with the gear on it that meshes with the crank gear?
I don't want to mess it up, and none of the sites I have looked at that sell parts has any information on it, or they're unwilling to share.
Anyone here who knows what I need to do?
And does anybody know where I can get a good repair book on these engines? Again, what I was able to find online was of no help.
This engine has a counterweight on it for balance, and I need to know how to synchronize it as well.
Any help would be greatly appreciated.
Rick
I don't want to mess it up, and none of the sites I have looked at that sell parts has any information on it, or they're unwilling to share.
Anyone here who knows what I need to do?
And does anybody know where I can get a good repair book on these engines? Again, what I was able to find online was of no help.
This engine has a counterweight on it for balance, and I need to know how to synchronize it as well.
Any help would be greatly appreciated.
Rick