Won't be hard to try it. I'm sure it will clear as the 2 front hinge parts are MIA! Including the part of the hood they bolt to! Gonna take a 'new' hood for it!Looks great Kenny, I bet the 316 hood will clear now also.
Last edited:
JD 112 Brush Guard/Tote Build
- Thread starter KennyP
- Start date
I got some of the latches done today. Here's what I started with.
Made up the pins only to fine they are .380". had to OS the holes for those to fit. Figured out where the roll pins needed to go and made notches in the main frames for them.
Got them ready to weld up. Decided to use the same roll pins for handles, so a trip the Ace is needed!
Made up the pins only to fine they are .380". had to OS the holes for those to fit. Figured out where the roll pins needed to go and made notches in the main frames for them.
Got them ready to weld up. Decided to use the same roll pins for handles, so a trip the Ace is needed!
I got it all welded together! The lower bracket needed a slight amount of tweaking due to weld pull. But I ended up with a nice snug fit with it.
Put the tote in and all is good there.
Even got a coat of paint on the tote since the fire was going. Bracket will have to wait a few days!
Put the tote in and all is good there.
Even got a coat of paint on the tote since the fire was going. Bracket will have to wait a few days!
Looks great Kenny.
Very nice job.
Very nice job.
Last edited:
