Started the cab heater installation

[MNGB]

If you get one of those let us know how you like it please. What I did last year was set mine and never touch it again. Of course this year being in a hurry I get in and first thing I do is push a wrong button maybe a half dozen times so I'm not sure where it's set at. It comes on just fine but I will probably be medium rare before it shuts off.
Those are good written instructions Gary. I'm going to book mark them as I know with my memory I'll be using them from time to time. Thanks!

Yes I thought she did a great job with her instructions, also have them bookmarked

 

[MNGB]

Quite a thing to learn. But I guess once you get it set, some of the functions you would never use, I suppose.

Noel

Noel the hardest part was getting it figured out at first after that I'll do like Chris just set it and go push the start button mine defaults to the manual settings so I can move it up or down on the Hertz numbers and when thru push the OFF button and done

 

[chieffan]

Noel the hardest part was getting it figured out at first after that I'll do like Chris just set it and go push the start button mine defaults to the manual settings so I can move it up or down on the Hertz numbers and when thru push the OFF button and done

The day of making things simple that work for us older people are long gone.

 

[MFDAC]

Did you or Chris get any s-word out that way, Gary? Aberdeen got about a half-inch last night. Rapid City must have gotten at least an inch by what I shoveled off the sidewalk when we got home tonight.

DAC

 

[Cvans]

Yes about a 1/2 to 3/4 inch. Can still see the grass pocking through.

 

[chieffan]

We got about an inch of wet stuff.

 

[MNGB]

We got about the same as Chris maybe a 1/2" or a bit less

 

[MFDAC]

Well, no luck getting to see you guys snow blowers in action---LOL!

DAC

 

[4getgto]

Well, no luck getting to see you guys snow blowers in action---LOL!

DAC

Yep they'll be blowing snow in tee shirts this year..

 

[chieffan]

Yep they'll be blowing snow in tee shirts this year..

Make getting back out a whole lot harder

 

[cjet69]

I got a gas welding rod put the inner O ring on the nipple slide it on the welding wire and it dropped right into the just like was needed put the outer O ring and some pipe sealant on the threads and tightened the retaining nut.

Thanks again, GB, I used your welding rod idea to install the nipple in my tank. Worked great.

 

[MNGB]

Thanks again, GB, I used your welding rod idea to install the nipple in my tank. Worked great.

Your welcome Chris, what is the tank for

 

[cjet69]

I bought one of those diesel heaters to try in our shipping container where I am setting up a small work area so I don't have to heat the 48 x 62 shop up just for a small job. I started this thread on the work bench that I put in.

New work bench for the shipping container

My brother has had this work bench sitting around for years. His plan was to use it as a reloading bench. He came up with something else, so I asked him what he was going to do with it. He said take it. Pulled a plywood shelf unit out that was heaped with cr@p. Put the work bench in its place...

tractorfanatics.com